5-Ply Silicone Hose 90° Bend (3.5", 4")

Custom 5-ply silicone, not a standard hose. We have these made to our own spec with 5 plies of reinforcement and a 6mm wall. Most off-the-shelf hoses are 4-ply with a 4 to 5mm wall. The extra ply and thicker wall hold their shape under clamp pressure and last longer in engine bay heat.

Use a 90° bend where your intake needs to turn a tight corner. It's the same bend we use in our own snorkel and airbox kits, so it's a straight swap if yours is worn or split.

Sizes

• 3.5": 89mm ID, 101mm OD, 150mm x 150mm legs
• 4": 102mm ID, 114mm OD, 150mm x 150mm legs

Features

• Custom 5-ply reinforced silicone with a 6mm wall
• Handles heat, vibration and water crossings without going soft
• Long 150mm legs you can trim to suit your setup
• Made for air intake plumbing. Not for fuel lines.

Clamps are not included. Each bend takes 2:

• 3.5" bend: 84-108mm stainless clamps (2 pack)
• 4" bend: 105-127mm stainless clamps (2 pack)

Specced and supplied by Canna Fabrication in Melbourne.